Device is fully supported in trunk versions r48924 and later.Įxperimenting with flashing, I've managed to mess up the firmware a few times. OpenWrt 15.05 works OK with exception of some LEDs and buttons (see GPIO section). The generated image cannot exceed 3,473,408 bytes so drop unnecessary packages. Generate your own OpenWrt image using the profile “Broadcom-mips74k-wl” for WiFi support. Don't try to use the sysupgrade or factory image, while they will allow us to flash, it will not boot. LEDE trunk works, you will have to flash using the serial console with TFTP. Please be aware of this fact, and use caution when deciding what version of OpenWrt to use on your specific device The physical label may state “rev0”, yet dmesg may state 'v1'. Initrd not found or empty - disabling initrd # Giving linux memsize in bytes, 33554432 # Transferring control to Linux (at address 80060000). Image Type: MIPS Linux Kernel Image (lzma compressed) Reserving 128k for boot params() at: 81f6ffb0 Reserving 36 Bytes for Global Data at: 81f8ffb0 Reserving 44 Bytes for Board Info at: 81f8ffd4 Top of RAM usable for U-Boot at: 82000000 # Tell u-boot to save parameters to the u-boot-env partitionsįor more information, read instructions on tnhh's website here: Installing OpenWrt onto a RAMdisk on WNR2000v1 Setenv bootargs "board=WNR2000 console=ttyS0,115200 mtdparts=spi0.0:256k(u-boot)ro,64k(u-boot-env)ro,3712k(firmware),64k(art)ro rootfstype=squashfs,jffs2 noinitrd" # We need to tell the kernel what board it is booting into, and where to find the partitions # Again, 0xYYYYYY is the length that tftpboot reports # Same to the uImage.bin, write it right next to sqfs.bin # Copy bit by bit 0xZZZZZZ bytes from offset 0x050000 # U-boot will tell you the length of sqfs.bin in hex, let's say ZZZZZZ # Load sqfs.bin on TFTP server, and put it to memory address 0x81000000 # Tell u-boot that the router should take the address 192.168.1.1 # Tell u-boot that we have a tftp server on 192.168.1.10 If you need to make changes after using the web browser setup, go to If prompted, log in as admin with password as the password.Flashing modified u-boot and pre-built OpenWrt Backfire on WNR2000v1.Select My wireless devices are connected to the Extender network.Select Use the same security mode and password as those for the existing network. Click Continue.Enter the wireless password for your existing wireless network.Select your network and click Continue.Open your web browser and type NETGEAR genie displays and prompts you to either go on with the procedure or manually configure the extender.Once connected, the PC to Extender light should turn on.This network is not secured so you can easily connect to it. Go to one of your wireless devices and look for the network NETGEAR_EXT.If you want to make changes on the extender, go to If prompted, log in as admin with password as the password.Use the same passphrase/network key as your main wireless network. Connect to the extender wireless network (SSID with _EXT at the end Example: ROUTER_EXT).Once the WPS lights on both devices stop blinking, ensure the Link Rate LED is lit.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |